Evolution 80GX Spécifications télécharger pdf (Page 18)

18 Hangar 9 Sukhoi SU-26MM SE

Engine Installation (DA85)

Required Parts

Fuselage assembly 90-degree snap link

1/4-inch lock washer (4) 1/4-20 blind nut (4)

2mm lock nut

2mm x 10mm socket head screw

2mm x 4-40 ball end with hardware

Pushrod wire, 18

-inch (470mm)

1/4-20 x 3/4-inch socket head bolt (4)

Required Tools and Adhesives

Threadlock Drill

Pin drill Felt-tipped pen

Tape or spray adhesive Hobby knife

Rotary tool Sanding drum

Cut-off wheel

Drill bit: 3/32-inch (2.5mm), 5/16-inch (8mm)

The fuel vent line has been wrapped up and back around the

tank to stop the fuel tank from siphoning fuel during flight.

 1. Secure the template (located on Page 31) for the

DA85 to the firewall using tape or spray adhesive.

Make sure to align the horizontal and vertical center

lines on the template with those on the firewall.

 2. Use a drill and 3/32-inch (2.5mm) drill bit to drill the

four locations for mounting the engine.

 3. Use the template to remove the area of the firewall to

allow the carburetor to extend into the engine box.

 4. Mount the engine to the firewall using four 1/4-20

x 3/4-inch socket head bolts and four 1/4-inch lock

washers. Make sure to use threadlock on the bolts

as well as the lock washers to help keep them from

vibrating loose.

 5. Attach the throttle linkage to the carburetor using

a 2mm x 4-40 ball link 2mm x 10mm socket head

screw and 2mm nut.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Evolution 80GX Spécifications Page 18