Evolution FURY5 Manuel d'instructions télécharger pdf (Page 12)

www.evolutionfury.com

When ﬁnally satisﬁed with the construction, tighten all nuts

and bolts securely, and remove the mounting bolts from the

corner holes. See Fig 4.

2. Attaching the main body to the stand

Warning

This machine is heavy, enlist competent help when fastening

this machine to its base.

The main body of the saw can now be attached to the stand

using the four bolts, washers and nuts provided. Ensure that

the saw is attached to the stand the correct way round. The

bolts fasten through the machines four corner mounting holes,

and through the four corner holes in the stand. See Fig 5

3. Table Extensions

Note

The pressed steel table extensions are not handed and can ﬁt

on either side of the machine. However the single hole in the

end of the extensions should be to the front of the saw table.

1. Attach the four bracing struts to the table extensions using

6mm hex bolts with a washer under the head of the bolt as well

as the nut. Position the front strut in the ﬁrst slot. Position the

rear strut in the single slot to the rear of the extension. Tighten

both struts in the middle of their respective slots. See Fig 6.

Fig 4

Overall view of completed

stand.

Fig 5

Saw on stand. Front and

rear mounting positions.

Fig 6

Close up view of bracing

struts attached to one

extension table.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Pas de commentaire

Evolution FURY5 Manuel d'instructions Page 12