Evolution FURY5 Manuel d'instructions télécharger pdf (Page 17)

www.evolutionfury.com

OPERATION

Controls

1. On/Off Safety Switch

Warning: Before turning on the switch make sure that the

blade guard is correctly installed and operating properly.

To start the machine, press the tabs on either side of the red

safety button and lift it and the switch cover plate upwards to

reveal the on and off buttons. Push the ‘ON’ button to start the

machine and the ‘OFF’ button to stop the machine. See Fig 18.

WARNING

Never start the machine until all safety checks and procedures

have been carried out.

2. Raising/Lowering the blade

Warning: Only make adjustments to the machine when the

machine is switched OFF and the blade is stationary.

The raising and lowering handle is used to raise or lower

the blade. Turn clockwise to lower the blade and counter-

clockwise to raise the blade. See Fig 19.

3. Tilting the Blade

The blade can be tilted up to 45

to the left.

To tilt the blade loosen the tilt locking lever and turn the tilt

adjusting wheel until the desired angle is achieved.

Tighten the tilt locking lever before using the machine. See Fig

20 (A) and Fig 20 (B).

4. Rip Fence Guide

The rip fence can be positioned either side of the blade and

is locked in position by using the locking lever. Push down to

lock, and pull up to unlock.

Note: The rip fence guide incorporates a magniﬁer to aid

reading the measurement scale found on the fence rail.

Fig 19

Close up view of elevating

handle.

Fig 18

Close up view of opened

switch.

Fig 20 (A)

Close up view of tilt

locking lever.

Fig 20 (B)

Close up view of the tilt

adjusting wheel.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Evolution FURY5 Manuel d'instructions Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Evolution FURY5