Evolution FURY5 Manuel d'instructions télécharger pdf (Page 21)

Fig 31

Use of pushstick.

Fig 32

View of machine set for

bevel rip cutting.

www.evolutionfury.com

Note

Check that the rip fence is locked in position and is parallel to

the saw blade.

Check that the riving knife is properly aligned with the saw

blade.

When ripping small section material a push stick should be

used to feed/guide the ﬁnal 300mm of the material past the

blade. A push stick should always be used when making cuts

of less than 300mm. See Fig 31.

When ripping long boards or large panels always use a work

support.

Feed the workpiece through the saw keeping it indexed

against the rip fence. Use smooth, steady pressure and

employ a push stick if necessary.

When the ripping width is greater than 300mm, and with care,

both hands can be used to guide/feed the material through the

saw. The operators left hand will be to the LH side of the saw

blade. The operators right hand will be close to the rip fence

on the RH side of the sawblade. Hands should never be in line

with the blade.

7. Bevel ripping

When bevel ripping material 150mm or narrower use the rip

fence on the RH side of the blade only.

See Fig 32.

MAINTENANCE

Warning

Ensure that the machine is disconnected from the mains

supply before any maintenance tasks or adjustments are

attempted.

Changing the Blade

Note

We recommend that the operator considers wearing protective

gloves when handling or changing the machines blade.

1 2 ... 16 17 18 19 20 21 22 23 24

Pas de commentaire

Evolution FURY5 Manuel d'instructions Page 21