Evolution FURY5 Manuel d'instructions télécharger pdf (Page 22)

Fig 33

Removing the access plate.

Fig 34

Close up of removing

the blade using the tools

provided.

www.evolutionfury.com

1. Disconnect the machine from the power supply

2. Remove the blade guard. (see Assembly 7)

3. Remove the table access plate by removing the two

countersunk head screws from either end of the access plate.

Lift the plate away and carefully store it and its ﬁxing screws

for future use. See Fig 33.

4. Raise the blade to its highest position.

5. Use the two blade changing tools provided. One to hold the

motor arbor, and the other to loosen the arbor nut. See Fig 34.

6. Remove the nut, outer ﬂange and blade.

7. Fit the new blade. Ensure that the teeth are facing to the

front of the saw, and that the arrow on the blade is in line with

the motor direction.

8. Replace the outer ﬂange and nut and tighten securely with

the spanners provided. Check that both blade ﬂanges are in

contact with the blade.

9. Replace the table access plate and its ﬁxing screws. Ensure

that the ﬁxing screws are correctly seated.

10. Replace the blade guard.

Cleaning

After each use the machine should be cleaned. Remove all

sawdust etc from the visible parts of the machine with a

vacuum cleaner. A vacuum cleaner can also be connected to

the machine dust extraction port at the rear of the machine.

This should remove debris from the inside of the machine.

Never use solvents to clean plastic parts, as solvents can

damage them. Clean only with a soft damp cloth.

Riving Knife

The riving knife is a very important component and comes

factory ﬁtted and correctly aligned and adjusted. The riving

knife prevents the work from binding as it passes through the

blade. Inspect the riving knife at regular intervals and replace

it if it is worn or damaged.

1 2 ... 17 18 19 20 21 22 23 24

Pas de commentaire

Evolution FURY5 Manuel d'instructions Page 22